中文

English

0510-86380736
PRODUCT Smash series Mixed series Dry series Granulator series Seve powder series Rubber machine series Universal pulverizer V type mixing machine Other series Industrial air cooler Contact Us Add:Jiangyin City, Zhu Yun Gu Road Town Industrial Park
Tel:0510-86380736
Fax:0510-86380736
Mob:13771223887
Email:mk@mingkejx.com
Current location:Home > NewsNews
Installation and maintenance of mixer and granulator

Operating procedures for mixers

Mixers are widely used in fine chemicals, feed, electronics, food, hard materials, ceramic materials, biology, medicine, non-metallic mining, building materials, coating industry, dye, chemical fertilizer and metal powder mixing (the main product of the company: feeding machine). For shear sensitive crystalline powder, batch product mixing, mixing liquid into solid.


Mixer installation and commissioning

1. After the mixer is in place, it must be put smoothly and fixed with anchor screws.

2. Before test run, the inner cavity of the mixer should be cleaned, and the front cover should be locked with a star handle.

3. After switching on the power supply, pay attention to the phase sequence and make the spindle rotate in the direction shown.

4. During the test run, attention should be paid to whether there is abnormal noise in the mixer, so as to check the mixer timely.

5, in the hopper, install the storage bag.


Knowledge of mixer maintenance

1. The lubrication finger in the bearing seat of the mixer should be replaced regularly.

2. The temperature rise of the mixing machine bearing seat shall not exceed 35℃.

3. Do not remove the mixer electrical equipment and belt protective cover at will.


Introduction to granulator installation and maintenance

One, the maintenance of granulating machine:

1, bearings for granulating machine full load, so good lubrication for the bearing life has a lot to do, it directly affects the service life of the granulator and availability, and requirements into lubricating oil must be clean and seal must be good, pelletizer in the main oil (1) rotating bearing (2) roll bearing (3) all the gear bearing, sliding plane (4) activities.

2, the newly installed wheel easily loose must be checked frequently.

3. Pay attention to whether the work of each part of the pelletizer is normal.

4, pay attention to check the wear degree of easy to wear parts, pay attention to replace worn parts at any time.

5, put the chassis plane of the mobile device, should be out of the dust and other things in order to avoid the opportunity to granulation can not be broken materials when the movable bearing can not move on the chassis, resulting in serious accidents.

6, bearing oil temperature rise, should immediately stop to check the cause to eliminate.

7, rotating gear in the operation of the impact sound should be stopped immediately check, and eliminate


Two, granulating machine installation test:

1, granulating machine should be installed on the level of concrete foundation, fixed with foot bolts.

2, installation should pay attention to the main body and horizontal vertical.

3. After installation, check whether the bolts in each part are loose and whether the door of the main engine bin is fastened. If yes, please tighten it.

4. Power line and control switch are configured according to the power of pelletizer.

5. After the inspection is completed, no-load test is carried out. Production can be carried out when the test is normal.

Mobile station Contact Add:Jiangyin City, Zhu Yun Gu Road Town Industrial Park
Tel:0510-86380736
Mob:13771223887
Email:mk@mingkejx.com
Copyright © 2022 Jiangyin Zhu Tong Minco Machinery Factory 苏ICP备12031660号-1 免责声明